Transfer Switches - Generac Power Systems PowerPact 6561 Installation Notes

GenReady Info:
This section can be found in the GenReady Load Center and Transfer Switch Owner's Manual, Page 5 and 6.
RTG-EZ Switch Info:
This section can be found in the Installation Guide For Pre-wired Automatic Switch/Load Center Models, pages
4 and 5.
RTSY/T/W, RTSR/P/C info:
This Section can be found in the Owner's Manual, Automatic Transfer Switch, page 4.
RTSB / RTSI info:
This section can be found in the Owner's Manual for RTSB200A3 /RTSI200A3, Section 2 page 3.
Transfer Switch Location
This section can be found on pages 2 thru 4 in the GenReady Load Center and Transfer Switch Owner's
Manual, RTG Installation Guidelines, RTSY/R-B/I Owners Manuals, and LTS Technical Manual
 Switch location is up to the contractor, homeowner, and Local Code Official. Generac recommends
that a licensed electrician or an individual with complete knowledge of electricity preform the
installation and wiring of the switch and connection to the generator.
Generac RTSY/RTST/ RTSW , & RTSB Service Entrance Switch

The RTSY/T/W/B Switch is NEMA-3R. It can be mounted outside near the Meter or inside near the
Panel Box.
 Note: Centerline of Utility Service Disconnect Breaker Should be no more than six feet from the
ground.
 RTSY/T/W, RTSR/P/C, RTSB, & RTSI you may remove the subpanel from the box when mounting to
prevent metal chips from contaminating the components.

Transfer Switches

(RTSW & RTSC will replace RTSY/T & RTSR/P Fall 2015)
32