Generac Power Systems PowerPact 6561 Installation Notes page 91

 Evolution controllers the accessory port is located underneath the controller covered with a decal
labeled Accessory Port 1.

Remove the decal and plug in the harness.
 The plug will only fit one way. Do Not force.
 The power wires of the harness go directly to the battery.
 Reconnect the battery Red (+) and Yellow fused (+) wires, then the two Black (-) wires.
 Replace the positive terminal Cover.
 Reinstall all covers, check to see that the unit is set to Off mode, reinstall the 7.5A fuse.
 Reinstall the T1 fuse and turn on the utility power supply to the transfer switch.
 Follow the install wizard instructions to reset the generator date and time.
 Place the generator in the AUTO mode, turn off the utility disconnect to simulate an outage.

The generator should crank and start. Let it run approximately 30 seconds, then turn the utility
disconnect back on.
 The transfer switch should transfer back to utility and the generator will cool down and turn off.

Verify that the Mobile Link unit's middle LED is illuminated and the bottom LED is illuminated or
flashing at this time.
 The top LED will not illuminate until enrollment/activation is complete.
91