Generac Power Systems PowerPact 6561 Installation Notes page 51

RTSY/T/W, RTSR/P/C, RTSB, RTSI, RTSJ, and GenReady Switches
 Run the A/C main wires (E1, E2, Neutral, and Ground as well as the control wires N1, N2, T1, 23, 0,
and 15B or 194) through the proper conduit to the generator.
All Switches
 Route the conduit With Power and Control Wires into the appropriate knockout hole in the back of the
generator.
 There are two knockouts on the Guardian Series in case you need to run the control wire in a separate
conduit.
51