Table of Contents
Advertisement
The NitroGro applicator offers row spacing options of 20", 22", or 30". The unit will be either be set up to or re-apply the outside row
("1 Up"), or skip a row ("1 Down"). Using your row spacing and whether your aplicator is "1 Up" or "1 Down", refer to the chart below to
determine the location and quantity of flow monitors for your applicator.
Row Spacing
20"/22"
30"
Using the charts on pages 20-31, decide which ball is best suited for
your desired GPA and Speed. Only choose one ball for all flow monitors.
Remove the balls that are not being used. The easiest way to remove
the balls is to remove the flow monitors and dump the balls into a
box. During this process, keep the hoses organized to ensure they
are returned to their original locations when you reassemble the flow
monitors.
To install a ball in the flow monitor, remove the clip and pop off the
hose on top of the flow monitor. Remove the screen, insert the ball,
and return the screen to its original position. To prevent the ball from
entering the hose, ensure the screen is above the ball. Clip the hose
back onto the flow monitor.
Flow Monitor Set Up
Flow Monitor Manifold Set Up (1 Up)
25 Coulters
8
9
17 Coulters
5
5
Flow Monitor Manifold Set Up (1 Down)
8
7
5
5
23 Coulters
9
7
15 Coulters
5
5
Hose
Screen
Clip
19
Advertisement
Table of Contents
