Table of Contents
Advertisement
•
Comply with ALL state and local laws governing highway safety and regulations when moving machinery on public roads.
•
Be sure an SMV (Slow Moving Vehicle) emblem is in place and clearly visible on the rear of the applicator. Position the SMV emblem
with one point of the triangle upward and as near to the rear and centered or as near to the left of center of the unit as practicable.
Secure the SMV emblem two to ten feet above the ground measured from the lower edge of the emblem. Before transporting,
ensure that all lights, reflectors, and the SMV emblem are clean and visible. Ensure the amber, red, and orange reflective tape on the
implement is in place and clearly visible. Before transporting, ensure all lights, reflectors, and the SMV emblem are clean and visible.
•
When transporting applicator, do not exceed 10 MPH in the field or over rough terrain. For highway transportation, do not exceed
20 MPH. Reduce transport speed when necessary to maintain full control. Never transport the applicator with contents in the tank.
•
Tongue weight when NitroGro is folded and empty for road transport is 600-1,000 lbs depending on the configuration. Negative
tongue weight (even intermittent) may cause instability when transporting. Add ballast to tractor as required. Never tow this
implement with a motor vehicle. Tow only with a properly ballasted tractor.
•
Be aware of overhead wires when transporting.
•
Ensure the safety chain has a rating greater than the empty weight of the machine.
•
Ensure wings are seated in the transport saddles before transporting.
The Transport Latches are designed for safe
transport. When the Transport Latches are
resting on the Main Frame and the pins are
installed, the Nitro Gro Applicator can not
lower.
Transporting
15
Advertisement
Table of Contents
