Table of Contents
Advertisement
6.04 Switching Grind Mode / Welding Mode
On the ProGuard exchange the Welding and Grind mode by pressing the knob on the shade knob outside of the helmet.
On Welding mode, by pressing the knob and hold for 2 seconds. The mode will be changed from Welding to Grind. The green Grind
light will flash (pos.4)
On Grind mode, By Pressing the knob and hold for 2 seconds. The mode will be changed from Grind to Welding. The green Grind light
will stop flashing (pos.4)
Turning clockwise =darker
Turning anti clockwise = clearer
6.05 How to Replace Battery
Swallowing batteries may lead to serious injury in as little as 2 hours or death, due to chemical burns and potential perfo-
ration of the oesophagus.
If you suspect your child has swallowed or inserted a button battery immediately call the 24-hour Poisons Information Centre
in Australia on 13 11 26 for fast, expert advice.
Examine devices and make sure the battery compartment is correctly secured, e.g. that the screw or other mechanical
fastener is tightened. Do not use if compartment is not secure.
Dispose of used button batteries immediately and safely. Flat batteries can still be dangerous.
Tell others about the risk associated with button batteries and how to keep their children safe.
When the LED (pos. 5) on ADF turns red, the battery needs replacement. Follow instructions below. Otherwise, ADF won't work correct
and can cause harm to the operator.
Remove battery cover from battery case (pos .1)
Take battery out and fit a new battery inside battery case. Note: "+" is on top. (pos. 2)
Assemble battery cover onto battery case.
14
Figure 6-2
! !
WARNING
Figure 6-3
0-5585
Advertisement
Table of Contents
