Section 7: Service And Maintence - ESAB Cigweld ProGuard Operating Manual

Section 7: Service and Maintence

ProGuard welding helmets should not be dropped. Do not place heavy objects or tools (hammers etc.) on or inside the helmet so as
not to damage the electro-optical filter.
Always make sure that the helmet is equipped with an outside and inner lens (in front of the filter on the outside and on the inside behind
the filter). These protection lenses must be replaced if damaged in any way (see overleaf). They are consumables and should checked
and replaced regularly.
The filter should be cleaned when changing the protection lenses.
This can be done by any of the following ways:
• Wipe with a clean, dry piece of cloth.
• Clean with a piece of smooth cloth moistened with pure alcohol.
• Clean with a commercial disinfectant
• If used properly the welding filter requires no further maintenance during its lifetime.
If a filter should be replaced on a ProGuard welding helmet, use exclusively certified products (DIN-CE marks). We recommend the use
of ESAB welding filters in all ProGuard helmets.
The filter itself contains no special or toxic products and can be disposed of in the same way as other electronic devices.
0-5585 17