Table of Contents
Advertisement
Remaining System Installation
M68EM05P18UM/D
MOTOROLA
When you have configured headers W1 and W2 and set switch SW1,
you have finished the M68EM05P18 configuration.
NOTE:
Ensure that the power to the HC05EVS is off before moving
any jumper settings on the platform board.
Find platform board jumper header J1 near the power connector. Make
sure that three fabricated jumpers are installed, per the diagram here.
To install the M68EM05P18 on the platform board, fit together EM
connectors P1 and P2 (on the bottom of the board) and platform board
connectors P3 and P4. Snap the corners of the EM onto the plastic
standoffs.
At this point, you are ready to make remaining cable connections, as
necessary, and restore power. For instructions, consult the HC05EVS
Operations Manual (HC05EVSOM/D).
HC05EVS Configuration and Operation
HC05EVS Configuration and Operation
J1
1
2
A14
A13
A12
A11
7
8
Remaining System Installation
FABRICATED
JUMPERS
37
Advertisement
Table of Contents
