Installation Instructions; Select Installation Location; Inverter Installation - Goodwe HT Series User Manual

4 Equipment Installation

4.1 Installation Instructions

• The installation height shall be parallel to the line of sight for easy operation and maintenance.
• The inverter must be installed away from flammable and explosive materials.
• The inverter must be installed in a place with high signal strength to ensure that there is no
strong electromagnetic interference or obstructions locally.
• The parameter labels and warning signs must be clearly visible after the inverter is installed.
• The installation location of the inverter shall avoid sunlight, rain, and snow.
Avoid sunlight Avoid rain Avoid snow

4.2 Select Installation Location

The following factors must be considered when choosing the installation location:
• The installation method and location must be suitable for the weight and size of the inverter.
• Install on a solid surface or bracket.
• The installation location must be well ventilated.
• The inclination angle of the horizontal installation shall be greater than 10°, and it is not allowed
to tilt sideways. The wiring area shall face down, and the horizontal installation must be more
than 500 mm above the ground.
Minimum 10°
More than 500mm
• To ensure good heat dissipation and easy disassembly, the minimum clearance around the inverter
must not be less than the following values, as shown in the diagram below.
＞1000mm ＞1000mm
07
Sunlight Rain Snow
＞600mm
＞600mm ＞1000mm
＞50mm
＞600mm

4.3 Inverter Installation

4.3.1 Wall Installation Procedure:
Step 1: Use the back hanger for
positioning. Drill holes in the wall with a
diameter of 13mm and a depth of 65mm.
The spacing of the holes is shown in the
diagram below.
889mm
Oblong hole 12x18
Step 3: Install handles or lifting rings on both sides of the inverter.
Step 4:
Method 1: Installers hold the handles and hang the inverter on the back hanger.
Method 2: Lift the machine for installation.
Step 2: Use the expansion screws in the
accessory pack to fix the back plate on
the wall.
Expansion tube Back hanger Screw
or
08