Using Special Mode
INSTALL Options
<STOP BIT>
<BUFFER CTL>
<DISC FAULT>
<PWRDWNHRS>
Safe Panel
•
If the value of safe panel is "YES", READY, PARK and LOAD require the ALT key to
be used as a two key operation for these functions in Normal Operation Mode of
printer.
•
If the value of safe panel is "NO", READY, PARK and LOAD key are operated as Nor-
mal Operation Mode, ALT key is not required.
Recalling Factory Settings
Factory settings are those settings pre-selected at the factory. To recall (reset) the factory
settings, select the RCALL-FACT function and press the ALT-NEXT key or the ALT-PRE-
VIOUS key.
Options under the MACRO, INSTALL, and Adjustment functions are all initialized to the
factory settings.
4-18
Values
Description
Word Length setting
Select the same word length setting that is
used by your computer or modem.
1 Stop bit per data byte
1 BIT
2 Stop bits per data byte
2 BIT
The ready/busy control method.
Hardware control via the DTR lead.
DTR
Data control using DC1 and DC3 control
XON/XOFF
characters.
For 6820 emulation
6820 PROT
Disconnect on a fault condition
Do not disconnect.
NO
DTR will change to inactive state.
DROP DTR
DTR will pulse to inactive and then back to
PULSE DTR
the normal active state.
Sets time after which Sleep Mode is automat-
ically activated
Disables Sleep Mode
0
Hours after which Sleep Mode is automati-
1-96
cally activated
Need help?
Do you have a question about the Tally MIP480 and is the answer not in the manual?