Table of Contents
Advertisement
EXPERT SETTINGS
PROFILE SETTINGS
In the following chapters, you can make ventilation settings for the
system profiles.
AT HOME PROFILE
When you want to set the At home profile settings, proceed as
follows:
1. The deployment wizard At home screen will open.
NOTE
When the units fans have been set (step 5 in the deployment
wizard) these values will default to the At home profile fan speed
value. We recommend this basic amount of ventilation for the At
home profile setting. If necessary, you can change it.
2. Set the At Home profile fan speed as a percentage of the
maximum by using the Plus and Minus buttons.
3. The At Home profile fan speed value is now set.
4. Press the Right arrow button.
5. The temperature setup screen is opened.
6. Set the desired supply air temperature for the At Home profile
by using the Plus and Minus buttons. You can adjust the
temperature in the range of +10°C – +5°C.
7. The At home profile supply air temperature is now set.
8. Press the Right arrow button.
9. The setup screen for the automatic fan speed control, based on
the relative humidity, appears.
10. Use the Plus and Minus buttons to select whether the
automatic fan speed control, based on the relative humidity, is
used or not.
11 The automatic fan speed control, based on the relative
humidity, is now set.
12. Press the Right arrow button.
13. The setup screen for the automatic fan speed control, based on
the carbon dioxide or VOC content, appears.
14. Use the Plus and Minus buttons to select whether the
automatic fan speed control, based on the carbon dioxide or
VOC content, is used or not.
15. The automatic fan speed control, based on the carbon dioxide
or VOC content, is now set.
16. Press the OK button.
(Integral CO
You can browse the settings of
the At home profile with the Right
arrow button.
13
© Airflow • We reserve the right to make changes without prior notice
DV50 DV80
Sensor)
2
NOTE
Advertisement
Table of Contents
