Turn On The Power; Connect The Cuff To The Device; Select An Operation Mode - Microlife WatchBP Office Vascular Instruction Manual

Taking measurements using the WatchBP
Office Vascular

Turn on the power

Turn on the device by pressing the
Connect the cuff(s) to the device
Connect the cuffs to the device by inserting the cuff connector into the cuff connector
socket.
Select the measurement arm(s) and ankle
You may select the arms and ankle (s) for the measurement by pressing the
button to scroll among the arm (s) and the ankle (s) for taking the
Press the
measurement. You may select one arm, both arms (for assessing of inter-arm difference)
or one arm and one leg (for ABI /baPWV assessment).
button to switch between each Mode.
Press the
Settings of the measurement
Part A)
The measurement program of the device can be set when the measurement of one
arm or both arms is selected, including Number of Measurements, Resting Time
(Countdown time), Interval Time, AFIB detector, CBP measurement, and Average
calculation (Discard 1st measurement or not)
This can be done as follows:
1 Set the Number of Measurements – Press the
when the device is in AUTO mode to first enter setting of
Number of Measurements. Use the
button to scroll down among one to six measurements.
use
button to confirm the number of measurements and
Prese
enter Resting Time setting.
2 Set the Resting (or countdown) Time – Press the
to scroll up and use
60, 120, 180, 240, 300 seconds of Resting Time. Prese
button to confirm and enter Interval Time setting.
10
button of the device.
button to scroll down among 15, 30,
button
button to scroll up and
button
button.