Memorisation Of The Gate Leaf Length (Opening And Closing) - Nice FILO Series Instructions And Warnings For Installation And Use

Table of Contents

Available languages

Aerial

A A erial

5.4 - MEMORISATION OF THE GATE LEAF LENGTH (opening and closing)

After recognition of the devices (Par. 5.3) it is necessary to make the control unit memorise the length of the gate leaf, which is measured from the clos-

ing limit switch to the opening limit switch. This operation is also required to calculate the deceleration points and the partial open point.

01. On the control unit (Fig. 18) press and release button P1: wait for the control unit to execute the gate opening manoeuvre up to the opening limit

switch. Only if the manoeuvre is NOT an opening movement, proceed as follows: a) press and release button P1 to lock the manoeuvre – b)

shut off power to the control unit – c) invert the position of the selector on the control unit (Fig. 19) – d) restore power to the control unit – e) press

and release button P1.

02. On the control unit (Fig. 19) press and release button P1: wait for the control unit to execute the gate closing manoeuvre up to the closing limit

switch.

Aerial

03. Lastly, perform various opening and closing manoeuvres while checking that the gate leaf stops at least 2/3 cm from the mechanical stops during

both the opening and closing phases (Fig. 20). If this distance does not match the proper distance, it can be modified accurately (for both limit

switches or only one), as shown in Fig. 21:

1) send a command to bring the gate leaf to the limit switch to be adjusted (opening or closing) - 2) inside the gearmotor and using the Allen key

provided, calibrate (+ ... -) the screw for adjusting the knob located in the highest position until the gate reaches a distance of 2-3 cm from the

mechanical stop. Repeat the same operation for the other limit switch, if necessary.

2/3cm

5.5 - MEMORISATION OF THE 1

The control unit incorporates a radio receiver for ECCO5 transmitters (various models): before proceeding with the remaining steps, it is necessary to

memorise the 1

transmitter in Mode 1 – see procedure below.

To memorise additional transmitters, see Par. 9.3.

Before running the memorisation procedure, it is advisable to read it and observe the indicated times.

This procedure allows for simultaneously memorising all the transmitter keys, by automatically pairing them to the commands shown in Table 1 below.

A transmitter memorised in Mode 1 can control only a single automation.

Flash

Fuse 1.6A T

ECSbus