Nokia Mobile Phones NSE-5 Series Service Manual page 155

PAMS
Technical Documentation
TX Data Type drop list (ALT+D): With this value the data transmission
pattern can be selected. Possible options are:
- Random pattern
- Continuous zeroes
- Continuous ones
The TX Data Type is greyed when the active unit is RX.
TX Power Level edit box (ALT+X):
With this value is possible to change the transmission power. The user
can give the needed power value or select the test value, which is tuned
with TX power tuning function. The test value is found at the end of the
list.
TX Power have value OFF and is disabled ( greyed ) when active unit is
RX. When the TX power is tuned with test value (smallest value) the TX
Power has value TEST .
Channel edit box (ALT+N):
User can enter here channel number that is used for both transmission
and receiving. The frequency of the selected channel is shown after
selection. The channel edit box is disabled (greyed) when the operation
mode is continuous.
Monitoring Channel edit box (ALT+M):
This field selects neighbour monitoring channel. The frequency of the se-
lected channel is shown after selection. The monitoring channel edit box
is disabled (greyed) when the operation mode is burst.
Continuous Mode Channel edit box (ALT+O):
To this edit box user can type continuous mode channel which may have
all channel numbers. The continuous mode channel edit box is disabled
(greyed) when the operation mode is burst.
The used frequency depends on the Active Unit. If Active Unit is RX,
then RX frequency is used, else TX frequency. The frequency of the se-
lected channel is shown after selection.
AGC Absolute edit box (ALT+L):
This selection allows user to edit AGC absolute value (value from A/D
converter).
When AGC Absolute value is changed the AGC dB value will be calcu-
lated depending on the AGC Absolute value. The AGC Absolute edit
box is disabled (greyed) when the operation mode is burst.
Issue 1 07/99
Service Software Instructions
Page 55
NSE–5