Table of Contents
Advertisement
3 Installation and Configuration
3.1 Configuration DIP Switch
SDU13742P00C100
SW1-[4:1] Config
CNF[2:0] Config
SW1-[1]
SW1-[2]
SW1-[3]
SW1-[4]
= Required settings when using S5U13U00P00C100 USB Adapter board
DIP Switch
SW1
S5U13742P00C100 Evaluation Board
Rev. 1.1
The S5U13742P00C100 evaluation board incorporates a DIP switch, jumpers, and 0 ohm
resistors which allow it to be used with a variety of different configurations.
The S1D13742 has 3 configuration inputs (CNF[2:0]). A DIP switch (SW1) is used to
configure CNF[2:0] as described below.
Table 3-1: Summary of Power-On/Reset Options
S1D13742
CNF0
Host Data lines are normal
CNF1
CNF2
PIOVDD output current = 6.5mA
-
not used
The following figure shows the location of DIP switch SW1 on the S5U13742P00C100
board.
Figure 3-1: Configuration DIP Switch (SW1) Location
Seiko Epson Corporation
Power-On/Reset State
1 (ON)
Host Data is 16-bit
Installation and Configuration
0 (OFF)
Host data lines are swapped
Host data is 8-bit
PIOVDD output current = 2.5mA
7
Advertisement
Table of Contents
