Dc Fan - Sony PXW-Z190V Service Manual

2-5. DC Fan

Preparation
Remove the outside panel assembly. (Refer to "2-2. Outside Panel Assembly".)
1.
2. Remove the CT-287A board. (Refer to "2-3. CT-287A Board".)
3. Remove the VC-41 board. (Refer to "2-4. VC-41 Board".)
Procedure
1. Remove the five precision screws, and then remove the VC heat sink assembly.
VC heat sink assembly
Precision screws
(P2 x 4)
2. Disconnect the harness from the connector (CN0701) on the DD-53 board.
3. Remove the two precision screws, and then remove the fan holder.
4. Pull the two fine-wire coaxial cables from the hole of the fan holder.
Arrangement of harness
Cable hook of the Projection of the
fan holder fan holder
(c)
Copper tape
Note
When installing the removed parts, arrange the harnesses as follows.
(a) Pass the harness through the notch of the fan holder, and then move the harness in the direction of the arrow.
(b) Align the end of the projection of the fan holder with the end of the blue tape.
(c) Align the edge of the cable hook of the fan holder with the end of the copper tape.
Notch of the
fan holder
Harness
(a)
Fine-wire coaxial cables
(b)
Blue tape
DD-53 board
CN0701
Harness
Hole
Precision screws
(P2 x 4)
Fine-wire coaxial cables
Fan holder
33