Board - Sony PXW-Z190V Service Manual

2-9. DC-184 Board
Preparation
Remove the outside panel assembly. (Refer to "2-2. Outside Panel Assembly".)
1.
2. Remove the CT-287A board. (Refer to "2-3. CT-287A Board".)
3. Remove the jack assembly. (Refer to "2-4. VC-41 board".)
4. Remove the inside panel assembly. (Refer to "2-7-1. Inside Panel Assembly".)
5. Remove the BT panel assembly. (Refer to "2-8-1. Handle Assembly".)
Procedure
1. Remove the two precision screws, and then remove the DC-184 board.
2. Disconnect the harness from the connector (CN0100) on the DC-184 board.
Harness
Holes
CN0100
Precision
screws
DC-184 board
(P2 x 4)
3. Install the removed parts by reversing the steps of removal.
Bosses
Arrangement of harness
Harness
DC-184 board
60