Seq - Korg Opsix Owner's Manual

See the graphic below.
Jump: When a knob is moved, the parameter value instantly changes to match the position of
the knob.
SST Hold Time
This controls the duration of Smooth Sound Transitions. It sets how long reverbs, delays, and note
releases continue to ring out after a new sound has been selected. The timer starts after all notes from
the previous sound are no longer being held down, and the sustain pedal is released.

SEQ

Trigger Quantize
This prevents the sequence from getting out of rhythm by lining up the timing of the sequencer steps
(quantizing) when using the step jump or key trigger function. The operation will be immediately
reflected when this is OFF, but setting this to 1, 2 or 4 steps will quantize the timing of the step
interval you set.
Record Quantize
This automatically corrects the timing of notes that are played during real-time recording.
Off: The note-on and note-off timing will be reflected into the START and GATE parameters
as-is.
Start: The note-on timing will always be at the beginning of each step. The note-off timing will
be reflected in the GATE parameter.
All: The note-on timing will always be at the beginning of each step. The GATE parameter will
be set to 75% or "TIE", according to the note-off timing.
Metronome
Sets whether the metronome will sound during real-time recording.
Initial knob position
Range is scaled around initial position
Current value: 80
40
0 100
Knob moved to minimum
Range is reset to even distribution
90
25
0
74
50
75
100