Korg Opsix Owner's Manual page 86

Effect name
Display Full name
DEC
Decimator
GRAIN
Grain Shifter
LIMIT
Master Limiter
COMP
Compressor
DLY/DLY e
Delay/Delay (BPM)
PDLY/PDL e Autopan Dly/Autopan
Dly(BPM)
TDLY/TDL e Tape Echo/Tape Echo
(BPM)
Parameter name
Knob
Display Full name
B
MIX Dry:Wet Mix
C
FREQ Sampling Frequency
E
BIT Bit Resolution
F
DAMP High Damping
Adds a lo-fi digital device-like feel. Use the FREQ parameter to control the sampling
frequency and the BIT parameter to reduce the data bit length, each for a different
kind of lo-fi texture.
B
MIX Dry:Wet Mix
C
TIME Time Frame
E
SPEED LFO Speed
F
RETRIG Retrigger
This cuts out the short waveforms from the input signal and plays them back
repeatedly, for an effect that changes the signal into a mechanical sound. The TIME
parameter sets the length of the waveform to cut, and the SPEED parameter sets how
fast to switch between the waveforms.
B
THRE Threshold
C
CEIL Out Ceiling
E
REL Release
This effect averages out the changes in volume of the input signal. Only signals that
exceed the specified level will be compressed, which brings down unnecessary peaks
in sound. The THRE parameter sets the level at which the compression is applied, and
the CEIL parameter sets the output level.
B
MIX Dry:Wet Mix
C
SENS Sensitivity
E
ATTACK Attack
F
LEVEL Output Level
This compressor models the extremely popular clean-sounding pedal effects.
B
LEVEL Delay Level
C
FDBK Feedback
E
DLY L Delay Time L
F
DLY R Delay Time R
This is a simple stereo delay with feedback.
B
LEVEL Delay Level
C
DEPTH Auto Pan Depth
E
DLY Delay Time
F
SPEED Speed
A stereo delay that pans the delay sound left and right using an LFO.
B
LEVEL Delay Level
C
FDBK Feedback
E
DLY Delay Time
F
DAMP Damping
This effect models tape saturation and tape echo. The DAMP parameter sets the
amount of high-end and low-end attenuation.
86
Range
0–100
1000–48000 [Hz]
4.0–24.0
0–100 [%]
0–100
0–100 [%]
1/48–4/1
Off, Mod Whl, Damper, Note On,
Velocity, LFO1, LFO2, LFO3
−30.0 – 0.0 [dB]
−30.0 – 0.0 [dB]
0.65–1000.00 [msec]
0–100
0–100
0–100
−Inf, −84.9–0.0 [dB]
0–100
0–100 [%]
0 [msec] – 2.73 [sec] / 1/48–4/1
0 [msec] – 2.73 [sec] / 1/48–4/1
0–100
0–100 [%]
0 [msec] – 1.36 [sec] / 1/48–4/1
0.020–20.000 [Hz] / 1/48–4/1
0–100
0–100 [%]
0 [msec] – 2.7000 [sec] / 1/48–4/1
−100.0 – +100.0 [%]