Korg Opsix Owner's Manual page 72

Post: Applies the velocity curve and transpose settings to the data just before it is fed into the
sound generator. The data that is affected by the settings (velocity curve and transpose) is the data
played with the keyboard of the opsix before it is sent to the sound generator, as well as the data
received via MIDI IN. This has no effect on MIDI data transmitted from MIDI OUT when
playing the keyboard of the opsix.
opsix built-in keyboard
Rx Transport
Sets whether start and stop messages (which are MIDI real-time messages) will be received.
Rx Prog Chg
Selects whether MIDI program change messages will be received.
Rx CC
Selects whether MIDI control change messages will be received.
CC#1 (Modulation Wheel), CC#64 (Damper) and CC#120 onward cannot be controlled
TIP:
using this setting.
Rx Pitch Bend
Selects whether MIDI pitch bend messages will be received.
Tx Transport
Sets whether start and stop messages (which are MIDI real-time messages) will be transmitted.
Tx Prog Chg
Selects whether MIDI program change messages will be transmitted.
Tx CC
Selects whether MIDI control change messages will be transmitted.
Tx Pitch Bend
Selects whether MIDI pitch bend messages will be transmitted.
MIDI IN
Velocity
Curve = 4
No
Transpose
MIDI OUT
Transmitted
72
Velocity
Curve
Scale Transpose
Note number changes
Received
Tone
generator