Detailed Editing - Korg Opsix Owner's Manual

3.
Press the YES button to show a confirmation message.
4.
Press the YES button again to randomize.

Detailed editing

You can make detailed edits as follows.
1.
Press the desired PAGE SELECT button between the MODE and EFFECT buttons to display the
corresponding page. To display one of the secondary pages as shown below the buttons, hold the
SHIFT button down and select the desired page.
2.
Sometimes the left side of the screen will indicate that multiple subpages are available. You can
use the PAGE < and > buttons to cycle through them.
3.
You can edit the parameters for each Operator on the MODE, PITCH and LEVEL pages. Use the
OP SELECT + and − buttons to select the Operator to edit.
Select the Operator
to edit using the OP
SELECT + and −
buttons
4.
Use the DATA ENTRY A–F knobs to change the parameters.
Each page's editable parameters are shown below:
MODE: Change the Operator mode and output waveforms for OP 1–6.
PITCH: Change the pitch of OP 1–6, as well as the pitch modulation from the LFO/EG.
LEVEL/EG: Set the output levels, EG and key tracking for OP 1–6.
MOD: Configure LFO 1–3 and EG 1–3.
FILTER: Set the overall filter used for OP 1–6.
EFFECT: Used for selecting effect types or making detailed edits to the effects.
ARP: Configure the arpeggiator.
25