Operators: Mode; Mode: Op1 - Korg Opsix Owner's Manual

OPERATORS: MODE

MODE: OP1...6 (Operator Mode)
MODE
Selects the Operator mode. (See "Operator modes", p.7)
WAVE
This selects the waveform of the oscillator. (See "Waveform List", p.77)
When "MODE" is set to FM (Frequency Modulation)
The pitch of an oscillator can be changed using the input signal from the modulator.
FB (Feedback)
Adjusts the amount of self-feedback from the Operator. When "WAVE" is set to "SIN", the sound will
become brighter the closer that the feedback value gets to 75%, sounding more like a sawtooth wave.
When the feedback value exceeds 75%, the sound will become more like complex noise as the value
gets larger.
WIDTH (Wave Width)
This sets the width of the waveform that was configured using the "WAVE" parameter. You can
control the value using V.Patch to get distinctive sounds like those used in dance music.
OFF 50% 25%
41