Troubleshooting - Korg Opsix Owner's Manual

Troubleshooting

If the opsix is not operating as expected, check the following points.
Power does not turn on.
… Is the AC adapter connected to an outlet?
…
… Are you pressing and holding down the
…
No sound is heard when the keys are played.
… Have you correctly connected the jacks of this keyboard to headphones or powered monitor
…
speakers?
… Check that the powered speakers or other amplification to which the keyboard is connected is
…
turned on, and that the volume is turned up so that you can hear it.
… Make sure the VOLUME knob is not turned all the way to the left.
…
… Is the Local Control setting on the GLOBAL MIDI page set to "On"? (→p.71)
…
… Are the parameters related to volume set to "0"?
…
… Is the cutoff value on the FILTER page set too low or too high? (→p.42)
…
Sounds cannot be edited.
… If the position indicated by the knob and the value shown on the main display are different when
…
operating a knob: When Knob Mode on the GLOBAL CTRL page is set to "Jump", the actual
parameter value may be different from the position indicated by the knob. (→p.73)
… If the edited program, has not remained in memory: You may have turned off the power before
…
the data was saved. In the case of programs, the edited settings will be discarded when you select
another program. Save your edited program before turning off the power or switching programs.
The program settings can't be saved.
… If the program you edited was not saved, did you using the PROGRAM knob to correctly select
…
the save location (program number)?
The arpeggiator won't start playing.
… Is the ARPEGGIATOR button lit or blinking?
…
… Are the Clock settings on the GLOBAL MIDI page set correctly? (→p.71)
…
The opsix is not responding to MIDI data transmitted from my external
device.
… Are the MIDI and USB cables connected correctly?
…
… Are the MIDI channels on the external MIDI device that is transmitting the data and on the opsix
…
set to the same channel?
… Are the settings on the GLOBAL MIDI page such as Rx Transport, Rx Prog Chg, Rx CC, Rx Pitch
…
Bend and so forth set to "On"? (→p.72)
Transpose, velocity curve and arpeggiator data are not being recognized
correctly.
… Are the Convert Position settings on the GLOBAL MIDI page set correctly? (→p.71)
…
(power) button when turning on the opsix?
96