Connecting Matrox Meteor-Ii /Standard For Pci To The Auxiliary; Power Supply Input; Matrox Meteor-Ii /Standard For Pc/104-Plus - Matrox Meteor-II /Standard Installation And Hardware Reference

26 Chapter 2: Hardware installation

Connecting Matrox Meteor-II /Standard for PCI to the auxiliary

power supply input

To use Matrox Meteor-II /Standard for PCI to power your camera:
1. Use the 4-pin power cable to connect the auxiliary power supply connector to the
power supply in the computer.
2. Ensure that the jumper is across the appropriate Matrox Meteor-II auxiliary power
supply selection pins, for the required voltage (5 V or 12 V). See Appendix B for
a diagram.
3. Use the DBHD44-TO-13BNC/O cable to connect your camera's video output
and power supply input to the video input connector. Note that the total current
drawn by all the cameras is limited to 1.5 A, and the circuit uses an auto-resettable
fuse.

Matrox Meteor-II /Standard for PC/104-Plus

Matrox Meteor-II /Standard for PC/104-Plus has four connectors, which are
indicated in the diagram below. The pinout for the video input connector is
described in Appendix B.
• Video input connector. A connector used to receive analog video, as well as send
and receive synchronization signals and power.
• PC/104-Plus (PCI) connector. An interface connector to send data across the PCI
bus.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com