Handling Components; Installation Overview - Matrox Meteor-II /Standard Installation And Hardware Reference

12 Chapter 1: Introduction
• The VMChannel interconnect kit (GEN-BUS/#) for Matrox Meteor-II /Standard
for PCI.
• DBHD44-TO-13BNC input cable with a high density 44-pin connector and
thirteen BNC connectors for the Matrox Meteor-II /Standard for PCI and
CompactPCI form factors. Six BNC-TO-SVHS (Y/C) adapter cables are supplied
with the DBHD44-TO-13BNC cable.
• DH44-TO-13BNC/O input cable with a high density 44-pin connector. This
cable is required if you want to connect to special input and output signals, such
as synchronization signals, control signals, and DC power output.
• 6U replacement bracket for Matrox Meteor-II /Standard for CompactPCI (3U).

Handling components

The electronic circuits in your computer and the circuits on
Matrox Meteor-II /Standard are sensitive to static electricity and surges. Improper
handling can seriously damage the circuits. Be sure to follow these precautions:
• Drain static electricity from your body by touching a metal fixture (or ground)
before you touch any electronic component.
• Avoid letting your clothing come in contact with the circuit boards or
components.
Caution Before you add or remove devices from your computer, always turn off the power
to your computer and all peripherals

Installation overview

The installation procedure consists of the following steps:
1. Complete the hardware installation as described in Chapter 2. If you have any
problems, refer to Appendix A.
2. Complete the software installation as described in the documentation
accompanying your software package.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
.