Bnc Connector; Vmchannel Interface Connector - Matrox Meteor-II /Standard Installation And Hardware Reference

Pin
20
22
23
24
26
28
30
1, 3, 5, 7, 9, 11, 13,
19, 21, 25, 27, 29
The mating connector included with the board is a 30-pin male, 0.050 pitch right
angle connector. For customers planning to build their own cable, parts can be
purchased from:
Manufacturer:
Connector:
This connector interfaces with a ribbon cable, 0.025 inch pitch (0.635 mm),
AWG #30 (solid wire).

BNC connector

The BNC connector provides a single composite input to the
Matrox Meteor-II /Standard board. Its pin assignments are as follows:
2
• 1: composite 1 or VID_IN1.
1
• 2 (SHELL): ground.
You can use a standard video cable (available from your local electronic store) to
interface with this connector.

VMChannel interface connector

The VMChannel interface allows Matrox Meteor-II /Standard to share data with
any Matrox imaging board that has a VMChannel interface capable of performing
the bus controller function. A VMChannel backplane (available with the
GEN-BUS/... interconnect kits) must be inserted across the VMChannel
interfaces of the boards.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Board input and output connectors
Signal I/O
VID_IN8 I
VID_IN9 I
OPTOTRIG- I
OPTOTRIG+ I
VID_IN10 I
VID_IN11 I
VID_IN12 I
GND
Fujitsu
FCN-217J030-G/O
51
Description
Analog Video Input #8 or Y4
Analog Video Input #9 or Y5
Opto-Isolated trigger negative input
Opto-Isolated trigger positive input
Analog Video Input #10 or C5
Analog Video Input #11 or Y6
Analog Video Input #12 or C6
Ground