Auxiliary Power Supply Selection - Matrox Meteor-II /Standard Installation And Hardware Reference

54 Appendix B: Technical information
For customers planning to build their own cable, parts can be purchased from:
Manufacturer:
Connector:

Auxiliary power supply selection

The following diagram shows the location of the auxiliary power supply selection
and their corresponding pin numbers:
As shown in the table below, place the jumper across pins 1 and 2 for a +5 V supply
Jumper
output and across pins 2 and 3 for a +12 V supply output.
Pin
1-2
2-3
1 2 3
pin pin pin
By default, auxiliary power supply is strapped for +5 V (pins 1-2).
Side view
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
VEN
2490-04PRT
+5V +12V
pin 2 pin 3
Description
+5 V (default)
+12 V