Matrox Meteor-Ii /Standard For Compactpci; Connecting A Video Input To Meteor-Ii /Standard For Pci Or Compactpci - Matrox Meteor-II /Standard Installation And Hardware Reference

24 Chapter 2: Hardware installation

Matrox Meteor-II /Standard for CompactPCI

Matrox Meteor-II for CompactPCI has three connectors, which are indicated in
the diagram below. Two of these connectors are located on its bracket, and are
discussed in detail in Appendix B.
• Video input connector. Used to receive analog video, as well as send and receive
synchronization signals and power.
• BNC connector. Used to receive composite analog video.
• CompactPCI connector. Used to connect your board to the PCI bus.
Connecting a video input to Meteor-II /Standard for PCI or
CompactPCI
You can connect video sources to Matrox Meteor-II /Standard's video input
connector, using the optional DBHD44-TO-13BNC cable. This cable has
thirteen BNC connectors and a 44-pin high-density D-Subminiature plug. The
wires of the cable are listed in the following table.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Video input
BNC
CompactPCI connector