Installing Matrox Meteor-Ii /Standard For Pc/104-Plus - Matrox Meteor-II /Standard Installation And Hardware Reference

Screw
Handle
3. Press the board firmly but carefully into the connector.
4. When the board is in place, the handle opens automatically, exposing a screw.
Tighten both this screw, and the one at the top of the bracket.
5. Connect your video sources. For details, see the Connecting external devices section.
6. Turn on your computer.
In some cases, when you boot your computer, Windows' Plug-and-Play system
will detect a new PCI card and you will be asked to assign a driver to it. At this
point, you should click on Cancel because the driver will be installed during the
installation of MIL or one of its derivatives.

Installing Matrox Meteor-II /Standard for PC/104-Plus

This section refers to the stand-alone version of Matrox Meteor-II /Standard for
PC/104-Plus. The version pre-configured for Matrox 4Sight-II is not discussed in
this manual. For more information, see Note about Matrox Meteor-II /Standard for
PC/104-Plus later in this chapter.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Installing Matrox Meteor-II /Standard
Back plate
of subrack
CompactPCI
connector
Guide
19