Creating A New Laser File For Cp4440-Rgb And Cp4450-Rgb - Christie CineLife+ CP4415-RGB User Manual

2. (Optional) Select Display White Test Pattern.
3. To create a new laser file, select Create.
4. In the Create dialog, type a name for the new laser file and select Create.
5. If the laser file will be associated with a 3D channel, select 3D Sync.
6. To set the value for White, select the current values and adjust them up or down as needed.
7. Set the brightness levels as required for your projection environment and allow the projector
to stabilize for 15 minutes.
System stability may be affected if you set a power level below the minimum power level
recommended.
8. If white or brightness is not at the target level, adjust the settings to achieve the target, and
then allow the projector to re-stabilize for an additional 3 to 5 minutes.
The projector is considered stable when there are no further adjustments and you obtain the
same screen state results after two sets of measurements, 5 minutes apart.
9. To save the new laser file, select Save.
Color sensor (CSense) data are displayed on the interface to provide feedback on the current
color sensor information.
Creating a new laser file for CP4440-RGB and
CP4450-RGB
Create a laser file to store the power settings for the RGB laser light source and the chiller setpoint.
The maximum (MAX) power limit for Red and Green changes according to the value set for the chiller
setpoint temperature. For Red, Green, and Blue power levels, system stability may be affected if levels
are set below the minimum (MIN) power limit shown.
To ensure color and brightness are held at the required levels for your installation, Christie
recommends that you enable LiteLOC for each laser file you create.
CineLife+ User Guide–CP4415-RGB, CP4420-RGB, CP4440-RGB, CP4450-RGB
020-103073-03 Rev. 1 (01-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
Managing the light source
27