Resetting The Controller; History Values - Pentair AUTOTROL 368 Installer Manual

Installer manual Autotrol 368 (604-606) - Programming
C# Cycle
C2 Brine draw
Slow rinse
C3 Repressurize
C4 Rapid rinse
C5 2nd backwash
C6 2nd rapid rinse
C7 Brine refill
6.10

Resetting the controller

All programmed settings with the exception of time of day can be reset. Entering the value "0" will
reset the flash memory to the factory default.
To reset the controller:
1. Press and hold
ð A small "u" will be displayed in the left digit.
ð The right digit will display the current system setting.
2. Press until the "u0" system is displayed.
ð Wait 5 seconds for the setting to be stored into the flash
memory. The display will return to the time of day.
ð The controller has now system 1 setting (default
setting).
3. Follow the steps of the system selection procedure to select
the desired system setting.
6.11

History values

The controller features a review level that displays the operation history of the system. To access
history values :
1. Press and hold
ð To view the "H" levels.
2. Press to navigate through the table.
ð When the desired code is reached, press
the value.
ð Some of the values have four digits. Press
the first two digits, then press
two digits.
36 / 60
Resin bed System u1
flow [minutes]
direction
↓ Calculated
None
↓
↑
↓
None Calculated
and simultaneously for 3 seconds.
and simultaneously for 3 seconds.
to display the last
System u2
[minutes]
Calculated
25 45
3 3
3 3
1 1
1 1
Calculated
to display
to display
Ref. MKT-IM-007 / D - 09.10.2020
System u3 System u4
[minutes] [minutes]
Calculated Calculated
25 45
3 3
1 3
1 1
1 1
Calculated Calculated