Fuel Tank Filler Pump (If Equipped) - Case CX145C SR Operator's Manual

Fuel tank filler pump (if equipped)

WARNING
Fire hazard!
When handling diesel fuel, observe the following precautions:
1. Do not smoke.
2. Never fill the tank when the engine is running.
3. Wipe up spilled fuel immediately.
Failure to comply could result in death or serious injury.
NOTICE: Do not put a moisture elimination product (water draining agent) in the fuel tank. (It may damage the engine).
ATTENTION: This pump is located in the front storage box and is to be used for fuel only. Use suitable fuel, (refer to
page 6-5).
1. Park the machine on flat, horizontal ground, stop the
engine and set the ignition key to the "On" position
(contact).
2. Take the inlet pipe out of the storage compartment.
3. Measure the height of the drum and place the identifi-
cation clamp (1) of the suction tube at a length slightly
less than that of the drum height.
4. Make sure that the end strainer of the suction tube is
correctly attached and then insert the suction tube in
the drum.
5. Remove the fuel tank filler cap.
WARNING
Burn hazard!
If the filler cap remains on during the refuel-
ing process, removing the cap after refueling
could cause an accident. To reduce this risk,
ALWAYS remove the fuel tank filler cap before
refueling with the fuel tank filling pump.
Failure to comply could result in death or se-
rious injury.
3 - CONTROLS/INSTRUMENTS
W0247A
3-79
1
09F438D8
2
8VHZ5J-002
3
33A5E527
W0099A