Removing The Compact Starter From An Infeed System For 3Ra6 - Siemens SIRIUS 3RA6 System Manual

Step
1
2
3
4
5.4.2.3

Removing the compact starter from an infeed system for 3RA6

Requirements
● Screwdriver with max. diameter of 7.5 mm and minimum shaft length of 100 mm for
releasing the compact starter
● The compact starter must be switched off (actuator set to
SIRIUS 3RA6 compact starter
System Manual, 09/2014, NEB560060102000/RS-AA/006
Instructions
Use a screwdriver to release the top
main circuit terminal.
Tilt the compact starter forwards so that
there is no risk of it snapping back into
the main circuit terminal.
Use a screwdriver to release the bottom
main circuit terminal.
Tilt the compact starter upwards and
pull it forwards in order to remove it
from the main circuit terminals.
NOTICE
Compact starter and infeed system material damage!
You can damage the compact starter and the infeed system if you remove the compact
starter from the infeed system for 3RA6 while the starter is switched on (actuator in the
READY position).
Make sure that the compact starter's actuator is set to the
remove the compact starter from the infeed system for 3RA6.
3RA61/3RA62 compact starter
Image
OFF position).
OFF position before you
5.4 Installing/removal
69