Installing/Removal; Installing The As-I Mounting Module - Siemens SIRIUS 3RA6 System Manual

Accessories
7.12 AS-i mounting module for 3RA61/3RA62 compact starter
7.12.4

Installing/removal

7.12.4.1

Installing the AS-i mounting module

Requirements
NOTICE
Damage to the AS-i mounting module!
If you install the AS-i mounting module on a compact starter that has a control supply
voltage of more than 24 V, the AS-i mounting module will be supplied with too much power.
This will damage the AS-i mounting module.
Only install the AS-i mounting module on a compact starter with a control supply voltage of
24 V.
Note
Damage to the AS-i mounting module!
This will damage the AS-i mounting module if it is electrostatically charged.
Please observe the ESD regulations when working with the AS-i mounting module.
● The control circuit terminals must be removed from the compact starter (24 V) (for
information on removing the control circuit terminals, please refer to "Installing/removal
(Page 144)").
● The compact starter must be switched off (actuator set to
Procedure
Step
1
212
Instructions
Insert the AS-i mounting module into the
mechanically coded guiderail on the
device from the bottom and then push it
back until you hear it engage.
OFF position).
Image
SIRIUS 3RA6 compact starter
System Manual, 09/2014, NEB560060102000/RS-AA/006