Table of Contents
Advertisement
2.
Attach the Access Point to the mounting disk by aligning the Access Point's
mounting holes (located on the underside of the unit) over the mounting disk's
raised notches (shown below).
3.
Slide the Access Point over the mounting disk until it locks into place.
Note:
All cable runs to a ceiling-mounted Access Point must comply with the
National Electrical Code (NEC).
Wall Mount
Follow these steps to wall mount the Skyline 802.11a Access Point:
1.
Place the AP Mounting Disk on the mounting location so that the side of the disk
that contains text is against the wall.
2.
If wall anchors are required for your installation, mark the centers of the two
mounting holes, remove the mounting disk from the wall, and drill a 3/16"-
diameter hole at each mark. Return the mounting disk to the wall and align it with
the holes you drilled.
Note:
Use only the two mounting holes shown below to secure the mounting disk
to a wall.
Mounting Notches
Mounting Notches
Mounting Holes
36
Advertisement
Table of Contents
