Installation Instructions; Introduction; Unpacking And Inspection; Reshipment Instructions - Racal Instruments 1260 Series User Manual

1260 Series User Manual

Introduction

Unpacking and
Inspection
Reshipment
Instructions
Option 01
Installation

INSTALLATION INSTRUCTIONS

This section describes the unpacking and inspection, reshipment,
installation and environmental requirements of the 1260 Series
switching modules.
Prior to unpacking the switching module, check the exterior of the
shipping carton for any signs of damage. All irregularities should
be noted on the shipping bill. Remove the instrument from the
carton, preserving the factory packaging as much as possible.
Inspect the switching module for any defect or damage.
Immediately notify the carrier if any damage is apparent. Before
use, have qualified personnel perform a safety check.
Use the original packaging when returning the switching module to
Racal Instruments for calibration or servicing. The shipping carton
and packaging will provide the necessary support for safe
reshipment. If the original packaging is unavailable, wrap the
switching module in plastic sheeting and use plastic spray foam to
surround and protect the instrument. Reship in the original or a
new shipping carton.
To install Option 01 to a 1260 switching module, carry out the
following procedure.
Remove the module top and bottom covers.
Remove the jumper board (Racal Instruments P/N 401951) fitted to
connector J4 on the switching module.
jumpers installed in the J4 connector that must be removed.
Remove the jumper board (Racal Instruments P/N 401951-003)
fitted to connector J3 on the switching module.
Align the 1260-01 card with the switching module, P3 to J3, P4 to
J4, and press the 1260-01 and the module firmly together to mate
Chapter 2
Note the 1260-40 has
Installation Instructions 2-1