Ttltrg; Yerr - Racal Instruments 1260 Series User Manual

1260 Series User Manual

TTLTRG

YERR

<error number>
0
1
2
3
4
5
6
7
8
9
20
21
22
23
24
25
26
27
31
40
TTLTRG <0|1|2|3|4|5|6|7|8>
Commands TTLTRG <0.....7> cause the connection of one of the
eight TTLTRG lines to a selected switching card. TTLTRG 8
deselects the TTLTRG line selected.
WRITE <module address>.<module specific syntax>
This command is supported by 1260 digital cards only. Refer to the
individual module sections for a description of the syntax and
functions performed.
YERR
This command causes the master switching module in a system to
transmit the location (<module address>) of the most recent error
and a two digit number (<error number>) that describes the error.
Refer to Table 3-2 for a listing of all possible
number> and the corresponding error descriptions.
Table 3-2, 1260 Series Error Codes
No error
Invalid module number specified
Specified module not installed
Invalid channel number specified
Invalid port number specified
Command syntax error
Read value larger than expected
Function not supported by module
Expected line terminator not found
Valid command not found
Exclude list too long
Channel entered on exclude list twice
Module doesn't allow exclude function
Scan list too long
Module doesn't allow scan
Equate list too long
Module entered on scan list twice
Incompatible modules equated or digital modules invalid
SRQMASK invalid
Number invalid as a test number
Error Description
values of <error
Operation 3-17