Configuring The Applications Card - Mitel MIVOICE OFFICE 400 Installation Manual

Configuring the applications card

Configure the applications card by executing the configuration processes in
the following order:
you can configure the OIP application. To secure the configuration data,
create a backup in the end.
Settings under
The general settings are described below.
Basic configuration
Parameter
Name sequence (as entered
in the communication server)
IP address
Communication servers in
subnet
Current password
New password
Windows work group set-
tings
CTI server configuration por-
tals
Applications Card CPU2-S
syd-0620/1.1 – R4.0 – 01.2016
Basic configuration,
Basic configuration
Explanation
Define the order of first name and surname here. The setting is applied
to all applications of the applications card. Select the same order as
defined in the communication server's phone books.
Note:
Perform this setting at the beginning of the configuration process and, if
possible, do not modify the setting in a fully configured system.
IP address of the communication server If the wrong IP address is
entered, the set up assistant has probably detected other communica-
tion servers on your subnet. You can see all the IP addresses of detected
communication servers under
the IP address of the correct communication server and click the
ton to apply it.
List of the IP addresses of all detected communications servers on the
subnet. To use any of the IP addresses, click the
The applications card current password used for the Windows operating
system as well as on the installed OIP application.
The new password of the applications card is automatically applied for
the Windows operating system on the applications card and for the
installed and OIP applications. To change the password may takes sev-
eral minutes.
These settings are relevant only if the applications card is to be inte-
grated into a Windows work group.
Note:
The applications card can be used in a domain environment, but should
not be a member of a domain.
This section contains a link to the OIP Toolbox, which is the OIP config-
uration console. Log on using the user name
cations card password.
Configuring the applications card
IP Network and Licenses. After that
Communication servers in
cpu2-emmc
subnet. Select
<< but-
<< button.
and the appli-
17