Transport - BORCAD Medical AVE2 Instruction Manual

6.2.Transport

Before transport, disconnect power supply cables, equipotential and other connection lines,
thus avoiding their pulling out.
The power cable must be fixed to the bed at the selected point using plastic hook! Never
wind up the cable on the bed/its parts, e.g. side handles, front section, handrails and other
items!
In case of visible damage of the power cable, do not use the birthing bed and/or the cable!
Always call technical service operator!
Only rear handles can be used for transporting the bed!
Do not transport any patient, when the bed is in "chair" position. Danger of injury to the
patient or damage of the equipment!
When transporting the bed within the building, be sure the patient and all items, e.g. cables
(incl. power cable), hose, pipe etc. are properly positioned within the circumference of the
unit. Danger of injury to the patient or damage of the equipment!
During transport, stability of the infusion stand must be monitored. Avoid hitting the
doors/ceiling lights. Before transport of the patient, always put the infusion stand to the
lowest position, thus avoiding injury to the patient or damage of the equipment.
BORCAD Medical a.s.
739 45 Fryčovice 673, tel.: +420 558 640 631
Warning:
Dangerous electric voltage
31
www.borcadmedical.com