BORCAD Medical AVE2 Instruction Manual page 30

When transporting the birthing bed (with/without the patient), the following
instructions must be observed:
1) Move the rest area of the bed to horizontal position, the handles being in
active (upper) position.
2) Move leg supports to horizontal position, thus constituting compact rest area
together with the mattress and avoiding leg support projection outside of the
circumference of the bed.
3) Disconnect power cable, equipotential and other connections, thus avoiding
their pulling out.
4) Use the handrail on the back section for transport of the bed.
5) When transporting the bed by one operator, activate the direction castor,
otherwise, the transport must be carried out by two operators.
6) During transport interruption, central brake must always be applied.
7) After the transport, connect the power cable and secure the bed with the
central brake.
When crossing transversal obstacles, lower the rest area to the lowest position.
Do not transport the bed at places with side slope exceeding 5°.
When crossing a threshold, its height must not exceed 20 mm.
Observe the following security hints when transporting the bed:
• Avoid crossing of cables.
• During transport, the power cable must be fixed with the hook.
• Be sure the castors are unlocked before transport (see section related to
adjustment of the castors and transport of the bed).
Move the bed only on the floors with suitable surface.
BORCAD Medical a.s.
739 45 Fryčovice 673, tel.: +420 558 640 631
Warning:
Caution
30
www.borcadmedical.com