Select The Desired Programme/Temperature; Select The Spin Speed Or The None Option; Select The Desired Options; Select The Delay Start - John Lewis JLBIWD 1403 Instruction Manual

Select the desired
programme/temperature
The display will show the duration of the selected
programme, calculated on the basis of the maximum
load for each type of fabric. The Start/Pause button
light will start flashing.
Select the spin speed or the
"None" option
Press this button repeatedly in order to select the
desired spin speed or the None option. If you select
the None option, the machine will stop at the end of
the programme with the water still in the tub. The
relevant light will light up.

Select the desired options

If you want to prevent the fabrics from creasing select
the Rinse hold option.
If your laundry has heavy stains and it is necessary to
prolong the washing time, select the Stain option.
The special detergent for stains (Stain remover) is
loaded from the compartment marked
If your laundry is only slightly soiled, select the Quick
option.
If you wish the laundry to undergo an extra rinse,
select the Extra Rinse option.
The relevant light illuminates.

Select the Delay start

Before you start the programme, if you wish the
start to be delayed, press the Delay start button
repeatedly, or keep it pressed, to select the desired
delay. The selected delay time value (up to 20 hours)
will appear on the display for a few seconds, then the
duration of the programme will appear again.

Start the programme

Press the Start/Pause button. The relevant light will
stop flashing. The machine starts operating.
If you have chosen a delayed start, the washer dryer
will begin the countdown.
The display will show the duration of the programme
or the selected delay.
How to change an option or a
programme during its cycle
It is possible to change some options before the
programme carries it out. Before you make any change,
you must pause the appliance by pressing the
Start/Pause button.
Changing a running programme is possible only by
resetting it. Turn the programme selector dial to Off
and then to the new programme position.
Start the new programme by dpressing the
Start/Pause button. The washing water in the tub will
not be emptied out.

How to interrupt a programme

Press the Start/Pause button to interrupt a
programme which is running, the corresponding light
starts to flash. Press the same button again to restart
the programme.
How to open the door during
the cycle of a programme
You can open the door, after having set the washer-
.
dryer to Pause, provided the following conditions exist:
• the machine is not in the heating phase beyond 55°C;
• the level of the water is not high;
If these requirements are met, when you pause the
washer dryer, the Door lock light goes off and the
door can be opened.
Should it not be possible to open the door, and should
it be absolutely necessary to do so, switch the machine
off by turning the selector dial to Off.
After a few minutes, you can open the door.
Pay attention to the level and temperature of
the water in the appliance!
When you close the door to restart the programme
turn the dial to the previous programme repeating the
options previously selected and press Start/Pause
button.

End of programme

At the end of the programme, the machine stops
automatically, the Start/Pause button light and the
Door Lock light go off and the display shows a flashing
0
zero
«
acoustic signals sound.
If you had selected the Rinse hold option, the Rinse
10
. It is now possible to open the door. Some
»