Hyundai 110D-9 Manual page 96

5) GEAR SELECTOR LEVER
Acceleration
Deceleration
Forward
Backward
110D9CD36
6) STEERING WHEEL
110D9CD33
7) BRAKE PEDAL
160D7ECD31
8) ACCELERATOR PEDAL
160D7ECD32
9) INCHING PEDAL
160D7ECD34
(1) This lever is used for gear selection, forward 3 stages and reverse 3
stages.
(2) If you push the gear selector lever, the truck moves forward, but
pulling the gear selector lever, the truck moves backward.
(3) If you turn the gear selector lever forward, the truck increases the
speed, but if you turn the gear selector lever backward, the truck
reduces the speed.
(1) A steering cylinder of the steering axle will operate the steering
function.
(2) Turning the steering wheel left, the truck moves to the left side and
turning it right, the truck moves to the right side.
(1) If the pedal is pushed, braking force is generated and bring the truck
to a stop.
Do not operate the truck with stepping on the brake pedal
※
unnecessarily, or bring premature wear of brake disc.
(1) This pedal controls the engine speed. The engine speed will
increase in proportion to the degree of force applied to this pedal.
(2) Unless this pedal is pressed, the truck will run at low idling.
(1) Inching pedal is used for fine control of forward and reverse
movement when lifting up or putting down loads.
Do not put your foot on the inching pedal or brake pedal unless
※
using it.
3-40