Hyundai 110D-9 Manual page 148

2) SELECTING DIRECTION OF TRAVEL
Forward
Neutral
Reverse
110D9OM95
3) USING THE ACCELERATOR PEDAL
160D7OM131
4) BRAKING PEDAL
160D7OM132
5) INCHING PEDAL
160D7OM133
Push the gear selector lever forward, center it , or pull it back
for FORWARD, NEUTRAL, or REVERSE, respectively.
Traction is disabled in NEUTRAL.
With the parking brake released and the gear selector lever in
FORWARD or REVERSE, put your foot on the accelerator
pedal and push down smoothly until the truck is moving at the
desired speed.
To stop the truck, lift your foot from the accelerator pedal and
put it on the brake pedal. Push down on the brake pedal in a
smooth, firm motion until the truck is stopped.
Stop the lift truck as gradually as practical. Hard braking
and wheel sliding are dangerous, increase wear, and can
cause you to loose a load and damage to the lift truck.
Can cause tip-over.
Use the inching pedal and the accelerator pedal in combination
to vary lift and travel speeds independently. The further you
depress the inching pedal, the more the driving clutch slips,
reducing travel motion. With the inching pedal fully depressed,
the brakes fully engage. You operate the inching pedal with
your left foot for precise control of travel speed, while you
operate the accelerator pedal together with the lift control to
vary lift speed.
In case of slipping the clutch, it can be caused to happen
heating problem in the system due to excessive friction of
the discs, and reduced a durability or a lifetime of the
components as result.
Pay particularly careful attention to do not press
repeatedly the pedal and it is essential to cut off the
power for travelling by pressing the pedal sufficiently to
prevent from heating problem.
5-18