Hyundai 110D-9 Manual page 228

(3) Lift chain wear and replacement criteria
New chain length
The distance from the first pin counted to the
last pin counted in a span while the chains are
lifting a small load.
Worn chain length
The distance from the first pin counted to the
last pin counted in a span while the chains are
lifting a small load.
Span
The number of pins in the length (segment) of
chain to be measured.
Pitch
The distance from the center of one pin to the
center of the next pin.
All chains must be replaced if any link has wear of 3% or more, or if any of the damaged conditions
notes above are found during inspection. Order replacement chains from your HYUNDAI dealer.
Replace all chains as a set. Do not remove factory lubrication or paint new chains. Replace anchor
pins and worn or broken anchors when installing new chains. Adjust tension on new chains.
Lubricate chains when they are installed on the mast.
Please refer to your service manual for additional information on lift chain measurement
and maintenance.
4
7-58
1 2 3
(EA)
D255OM15