Hyundai 110D-9 Manual page 214

34) BRAKE COOLING OIL AND STRAINER
(1) Check the oil level.
(2) If oil level is near or under the lower limit, add oil
immediately.
(3) Change oil and strainer completely every 1000
hours operation.
35) LUBRICATION
(1) Supply grease through the grease nipple, using
grease gun.
(2) After lubricating, clean off spilled grease.
Put the parking brake switch in the LOCK
position and fix front and rear tires with
blocks.
Set the mast and forks in a stable position.
(3) Lubrication points
Fork adjust cylinder : 2EA
Forks : 2EA
Tilt cylinder : Left/Right, 2EA
Lift chain : 2EA
Mast support : Left/Right, 2EA
Steering axle : 5EA
Hydraulic pump drive spline : 1EA
36) FORKS REPLACEMENT
Lower the fork carriage until the forks are
approximately 25 mm (1 in) from the floor.
Release the fork retainer and remove the cover.
Slide one hanger bar at a time out of carriage
assembly.
Remove only one fork at a time.
On larger forks it may be necessary to use a
block of wood.
Reverse the above procedure to install the forks.
Axle cooling oil
reservoir tank
Frame - RH side
3
1
2
1 Fork adjust cylinder (2EA)
2 Fork (2EA)
3 Tilt cylinder (Left/Right, 2EA)
4 Lift chain (2EA)
5 Mast support (Left/Right, 2EA)
6 Steering axle (5EA)
7 Hyd pump drive spline (1EA)
Hanger bar
7-45
Cap
Plug
Strainer
110D9MI60
4
5 3 6
7
110D9OP17
Fork retainer
Cover
Bolt
100D7MS07