Programming Auma Matic Ex; Functions Of The Diagnosis Leds On The Interface Board (Standard Version) - AUMA SAM Ex 07.1 Operation Instructions Manual

Operation instructions

15. Programming AUMA MATIC Ex

Figure P: AUMA MATIC Ex standard version
Power supply unit
Reversing contactors
Signal and control board

15.1 Functions of the diagnosis LEDs on the interface board (standard version)

Multi-turn actuators SAM Ex 07.1 - SAM Ex 16.1 / SARM Ex 07.1 - SARM Ex 16.1
Electrical connection
Plug/socket connector
to actuator
During all work at the AUMA MATIC Ex observe:
Work at the open actuator under voltage must only be
performed if it is assured that for the duration of the work
there is no danger of explosion.
V14 is illuminated:
V15 is illuminated:
Figure Q1: Cover plate above interface board
LEDs STOP, CLOSE, OPEN
indicate available remote control commands.
Cover plate
Interface board
Logic board
Phase failure and/or motor protection tripped,
reset by selector switch position III at local
controls
Torque fault: Torque switch operated in
mid-travel
AUMA MATIC Ex
Local controls
19