Engine Removal - Toro GrandStand 74504TE Service Manual

ENGINE
Engine Removal (Figure 21)
1. Turn off the engine and remove the key from the
ignition.
2. Lower the deck to the lowest height of cut.
3. Turn fuel shut-off valve to the OFF position.
4. Remove the negative and positive battery cables
from the battery.
5. Drain the oil from the engine using a drain hose.
6. Remove the oil drain hose from the engine. Set
aside for reuse.
7. Remove the muffler shield by removing the bolts on
the front of the muffler shield and 2 bolts on the rear
of muffler shield (Figure 22).
5
8. Loosen and remove the 2 bolts; one on left and one
on right muffler brackets.
9. Loosen and remove the 4 bolts securing the muffler
to the engine.
10. Remove the 2 bolts securing the muffler bracket to
the engine.
11. Set the muffler aside to reuse.
12. Remove the throttle or choke cable (may or may
not have choke cable depending on engine type)
(Figure 23).
5-2
Figure 22
Figure 23
13. Remove the fuel line from the pump. Drain fuel
from the line.
14. Remove the vent line from the air cleaner.
15. Unplug the engine-wiring harness from the Toro
wiring harness.
16. Remove bolt from the engine ground.
17. Remove the deck belt from the PTO clutch.
18. Pull down the kneepad.
19. Remove the 4 bolts securing the cross brace.
20. Remove the fuel line and vent line from the top of
tank.
21. Remove the fuel tank and place on a flat surface.
22. Remove the deck drive belt.
23. Remove the drive idler spring.
24. Remove the drive belt.
25. Remove the bolt-holding clutch on the crankshaft.
26. Disconnect wiring lead on the clutch.
27. Remove the pulley, PTO, key, and drive pulley
from the crankshaft.
TORO®- Grandstand Service Instruction Manual