Deck Removal; Deck Installation - Toro GrandStand 74504TE Service Manual

Deck Removal (Figure 37)
1. Place 2, 2x4 under the deck to prevent damage.
2. Lower the deck to lowest height of cut.
NOTE: Lowest height of cut 1.5 in.
3. Remove 2 bolts on the strut plate that secure to the
deck.
4. Remove the 2 bolts that secure the left and right flat
lift link to the deck
5. Remove the left and right bolts that hold the deck lift
chains to the deck.
6. Loosen the 4 yoke jam nuts.
NOTE: This will aid in deck install and leveling.
TORO®- Grandstand Service Instruction Manual
MOWER DECK
Deck Installation (Figure 37)
1. Place jacks under the deck to lift the deck into
position.
2. Insert bolts from outside the plate strut and attach to
the deck. Ensure bushing is in place on both sides.
Torque to 32 +/- 4 ft. lbs.
3. Install bolts from inside the flat link and deck.
NOTE: Wait till deck is completely on before
tightening down. Torque to 50 +/- 5 ft. lbs.
4. Install bolts from inside to outside the lift chain and
attach to deck. Wait to tighten bolts.
5. Level the deck, see "Deck Leveling," page 7-1.
7
7-3