Wiring Harness Removal; Wiring Harness Installation - Toro GrandStand 74504TE Service Manual

ELECTRICAL
Wiring Harness Removal (Figure 39)
1. Lower the platform.
2. Lower the knee cushion.
3. Lower the deck to the lowest height of cut.
4. Disconnect the wire harness. Remove the fuse
block.
5. Disconnect the wire harness left hand bail switch.
6. Disconnect the wire harness right hand bail switch.
7. Disconnect the wire harness from the ignition
switch.
8. Disconnect the wire harness from the PTO switch.
9. Disconnect the wire harness from the hour-meter.
10. Disconnect the wire harness start relay connector
from the relay and tower.
NOTE: On machines with Kawasaki engines, there
will be a fuse holder attached to the start
relay connector that needs to be removed .
11. Disconnect the ground from the engine.
12. Disconnect the wire harness from the engine
wiring harness.
13. Disconnect the wire harness from the clutch.
8
8-2

Wiring Harness Installation

(Figure 39)
1. Install the wire harness to the fuse block into the
tower.
2. Install the wire harness to the right bail switch.
3. Install the wire harness to the PTO switch.
4. Install the wire harness to the hour-meter.
5. Install the wire harness to the ignition switch.
6. Install the wire harness to the left hand bail.
7. Install the start relay block to the tower.
NOTE: If the machine has a Kawasaki engine then
ensure you install the 25 amp fuse and
holder at this step.
8. Install the wire harness ground to the engine.
9. Connect the wire harness to the engine wire
harness.
10. Connect the wire harness to the clutch.
NOTE: Ensure the wire harness routing does not
interfere with any moving parts.
TORO®- Grandstand Service Instruction Manual