Engine Installation - Toro GrandStand 74504TE Service Manual

28. Remove the 4 bolts securing engine to the frame.
(torx bit required).
29. Remove the engine.
TORO®- Grandstand Service Instruction Manual
Engine Installation (Figure 21)
1. Install the oil drain tube to the engine. Torque to 20
+\- 3 ft. lbs
2. Lower engine to the frame and secure it with 4
mounting bolts. Torque to 30+/- 4 ft. lbs
3. Add anti-seize to the crankshaft.
4. Install the drive pulley with the key-way. Ensure the
larger diameter end is toward the engine.
5. Install the clutch, spring washer, and washer.
Ensure clutch is in the clutch stop. Torque to 55 +\-
5 ft. lbs. Add Loctite to the bolt.
6. Reconnect wire lead to the clutch.
7. Install muffler to the engine.
8. Install mounting brackets to the engine using 2
bolts.
9. Attach the muffler to the brackets. Muffler guard
should have about 1 in. clearance on each side of
the muffler.
10. Install drive belt to the pulley.
11. Install the drive spring.
12. Connect the wiring harness.
13. Attach the engine ground and wires.
14. Connect the vent hose to the air cleaner.
15. Connect the fuel line to pump.
16. Install the fuel tank.
17. Install the vent hose and fuel hose on the tank.
18. Install the cross bracket and the 4 bolts. Torque 24
+\- 3 ft. lbs.
19. Lift the kneepad and install.
20. Install the muffler shield (Figure 24 and 25).
ENGINE
5
5-3